Buy Moog K80002 Camber Shim KitMoog K80002 Camber Shim Kit Product Description:
- Moog Chassis K80002 Suspension and Alignment
- Genuine Moog Part
Product Description
Camber/Toe Adjusting Kit
Customer Reviews
Most helpful customer reviews
0 of 0 people found the following review helpful.
By Roger
I too have an 03 ZX3 with excessive rear camber. After receiving the Moog plate set...I decided not to use both the 1/2 * and the 1* plates on each wheel. Why? Because Moog doesn't actually recommend it...the instruction sheet says to use either the 1/2* or the 1* plates. Using these plates put a "sideload" on the bolt heads holding the rear spindle on the car...maybe 1.5* is a little too much??? At any rate they were fairly easy to install. I didn't use the rivets...I did RTV the plates in place over the old rivets. The (4) bolts do all the holding in place.I also added a "rubber donut" to each coil spring. This raises the suspension slightly (helps sagging springs)...stiffens the spring...and might reduce camber by maybe 1/2* or so. They also reduce "rolling" of the car on corners...which tends to wear the tires more.note: you do not get 8 bolts...only 4...you reuse 2 of the originals on each wheel.
0 of 0 people found the following review helpful.
By J. Bohner
I picked up a 2003 Ford Focus and noticed that the rear wheels had an extreme negative camber. It was roughly about 2 degrees leaning in. I discovered that the Ford Focus has no adjustment for camber on the rear wheels, only a toe adjustment. I've seen some adjustable camber bolts on the market but this involves grinding off the welded-on factory nut on the trailing arm. These shims offer a total of 1-1/2 degrees of negative or positive adjustment (there's a 1-degree shim and a 1/2-degree shim). Installation was pretty easy (depending on how mechanically inclined you are) and after I was done my rear wheels are nearly perpendicular to the ground. I should have a more even tire wear as a result. These shims are high quality (made by Moog) and come with longer bolts and mounting rivets. If your Focus has a bad negative rear camber this is the kit to get...well worth the price.
Latest Price: See on Amazon.com!
More Info: See on Amazon.com!
See Customers Review: See on Amazon.com!
